This project was created using a program called AutoCAD. This was my first project where a revision was required. A revision is when your supervisor or client requests a change to the part you designed after it was finished. Those edits can be found on the revision table in the drawing set, or you can see where something was changed based on the blue triangles in the drawing. This specific assembly required an assembly section view and I learned how to efficiently take an assembly section view and turn it into 3D parts. This wheel was created first in the 2D drawing that you see below. Then, portions of those 2D parts were later extruded to create the parts you see in the exploded assembly. Finally, I assembled those parts to create the isometric views.